Goldmaxx Power coil assembly [solved]

[hammyman]

I doubt you would get them for Sunday. But its worth getting them for future use. I had gone through countless XP bolts[which are not cheap]I got 10 of these 6mths ago and am still on the first one

[bri_on_1]

They must sell plastic bolts in diy stores? worth a look me thinks

[dolph]

you should of got a spare bolt and nut when you got the machine at least I did anyway

[bri_on_1]

Got mine secondhand

[hammyman]

They must sell plastic bolts in diy stores? worth a look me thinks

Trust me Bri.........they dont.I wouldn't waste the time/petrol looking.Ive been there.....got the T shirt.The ebay link was the only place I found them.

[Radek]

I just took mine apart and broke the bloody bolt i got a rally on sunday! gona phone regtons in the morning

I'm really sorry mate If you were closer, I'd give you my spare one for your rally...

Anyway, I've had a look at Regton's website, and their 9" standard coils have both holes the same size, which I believe means, they use two rubber washers... my coil has two holes of different size...

I'm going to send an e-mail to the seller...

[hammyman]

I just took mine apart and broke the bloody bolt i got a rally on sunday! gona phone regtons in the morning

I'm really sorry mate If you were closer, I'd give you my spare one for your rally...

Anyway, I've had a look at Regton's website, and their 9" standard coils have both holes the same size, which I believe means, they use two rubber washers... my coil has two holes of different size...

I'm going to send an e-mail to the seller...

I think you have that wrong[unless Regtons are using an old picture]You have the new coil and the correct fitting kit for it.Just looked at Regtons site.That is the old coil

[Radek]

Finally... you are right, I've got the right kit... the only thing was, because it was new, to fit the 'top hat' into the larger coil hole, I had to use some force... I was going to make a video to show you that it didn't fit and... ready...

Thanks for advices and pictures and sorry for confusion...