I firstly set it to- wet beach mode and then set the ground balance to pumping mode but failed about 8 times and then gave up and set it to beach.
I went along for quite some time thinking these settings were great as it was very quiet !
When I actually found a signal, I turned out my first shovel full and gave the area a quick sweep and the signal was gone !
So I thinned out the mound which wasn't big by any means untill I found a very small piece of aluminium about 2mm in dia, but it would only pick it up if it was very near the suface so I am thinking im only penetrating about an inch if that ???
My life story
The beach was wet and gravely 1= 6mm dia gravel...
Has any one foud the same on wet beach or have you got any setting you have found better or do I give up on the beach?















Like Tommo suggested, I think ill take some coins with me next time I go to test with as I would like to do the wet stuff
thanks for your input so far as they say two brains are better than one