- Posts: 2073
- Joined: Sun Jan 22, 2017 12:25 pm
- Location: Newbury
- Has thanked: 805 times
- Been thanked: 1187 times
Well that is what happened to me today. I went over the same footpath area that I had the milled silver, and the crotal bell from with my Rutus, only this time I used my XP GMP with Nel Tornado coil. but that is not the end of the story, because Derek also swung over this same area with his XP Deus with 11" coil. It just goes to show just how much we really do miss
Now I love Sixpences, which is lucky as I seem to find one very time I go out, as it happens I love "hammies" too, but I can't seem to find those So first find this evening was a Sixpence...
We shall now use this sixpence as a size reference to the other items...
next up was a livery button, we have had quite a few of this design.
Then I found this bronze alloy item, but what is it?
And then this unusual item...
Finally I did mention I was using a NEL coil, so what else could I find?
No idea what it is though?
Walk that line, torn apart
spend your whole life trying.
Ride that train, free your heart,
it's midnight up in Harlem.
Midnight in Harlem, Tedeschi Trucks Band
- Posts: 9110
- Joined: Sun Jul 10, 2016 6:54 pm
- Location: Oxfordshire
- Has thanked: 3643 times
- Been thanked: 3888 times
Hammered silver 2019 - 12
- Posts: 4211
- Joined: Sat Feb 18, 2017 8:19 am
- Location: Norfolk
- Has thanked: 1161 times
- Been thanked: 1399 times
Aside from day-to-day variations in soil conductivity, swing and search technique, new ploughing etc determining what you might find, there's also the equipment. At the moment I have the 400i with standard coil but I can upgrade the coil and go over it all again. I can upgrade the machine and go over it all again. I can upgrade that machine's coil and go over it all again. So with all the combinations of kit available coupled to what I will be missing naturally, I've come to realise that the acreage I have is more than enough to keep me out from under 'er indoors's feets for years to come.
Thanks for the confirmation, Bargeman.
Some sort of electrical gubbins(I'm told it's a Deus). In various colours
Here's the experiment in the garden with a single target buried at 6".
Disc 0, Sens 95, GB~55, Tone 1 or 1+. Two good beeps in one direction but nothing at 90 degrees. Reading of 23-25, "iron" but no "burp". Tones are strong but dull / low.
Disc 0, Sens 95, GB~55, Tone 2+. 23-35 and "iron" + "burp".
Disc 35, Sens 95, GB~55, Tone 2+. Same reading, no "burp" just a tiny click one way (not double click), and nothing at 90 degrees.
So I need to go back and dig a lot more signals with low dull tones to make sure. I'm now not confident that discing out iron is only doing that although I could be in for a lot of scrap! So is the field done .... I have no idea....I'll know around October!
And the target, thin gold ring circa 1800's!
- Posts: 9290
- Joined: Wed Dec 10, 2014 6:15 pm
- Location: Kent
- Has thanked: 1922 times
- Been thanked: 5134 times
In my experience the best finds usually come after all the surface targets are long gone and you have to slow down and concentrate to get any signals at all. Once a site is clear it is also a great opportunity to investigate some of the iffy signals properly. If about 5-10% of the bits in my finds pouch are small iron items then I reckon to have the discrimination set about right and my ears tuned in properly. Any less and you will be leaving keepers in the ground too. I have also noticed that different machines will often get targets that another machine doesn't and sometimes even relatively minor changes, like a new coil or a new pair of headphones will do the same thing.
Lovely finds, I love Item no. 3,4 and 5. I think its an old button/ badge from a horse harness, used with Leather and not fabric, lovely piece.
Rugby badge is also very nice, both unusual designs.
Well done saving them.
Try the Rutus with the Concentric coil and use similar frequency to your Gmp, it will be interesting to see how you get on even after previous finds with different machines.