ALERT The MDF has a monthly Prune of all Members that have Zero Posts to their Accounts to Free up Resources. However Just 1 Single Post will keep your account open indefinitely.
Only for the discussion of the Minelab Equinox series of metal detector within this forum.
- Posts: 1006
- Joined: Fri Jul 28, 2017 10:30 pm
- Has thanked: 822 times
- Been thanked: 296 times
Before I got the Equinox, I was used to using machines where you could 'ratchet' the pinpoint mode, i.e. narrow down the location of the target with each pass of the search coil. On some machines I had to press/release, press/release the pinpoint button to do this.
I've read the manual on the Equinox, and supposedly the pinpoint mode narrows with each pass of the search coil over the target (don't need to press any buttons from my understanding, once in pinpoint mode.)
It might just be me, but I am not noticing the pinpoint signal becoming narrower.
What is everyone else's experience?
Minelab Equinox 800. CTX 3030. Visua Pinpointer.
This topic has 7 replies
You must be a registered member and logged in to view the replies in this topic.