Only for the discussion of the Minelab Equinox series of metal detector within this forum.
- Posts: 830
- Joined: Fri Jul 28, 2017 10:30 pm
- Has thanked: 645 times
- Been thanked: 226 times
I was reading on another website somebody reporting that their charging plates have turned green and corroded?
Has this happened to anyone else out there?
I just checked mine, and they appear to be fine, so far!
Minelab Equinox 800. CTX 3030. Intey Pinpointer.
- Posts: 2243
- Joined: Fri Nov 23, 2012 6:36 am
- Has thanked: 29 times
- Been thanked: 107 times
mine are fine and its been in salt water, however i rinse my gear in clean water as it all gets a tad sticky with the salt if i dont.
Just dig it and put your mind at rest
- Posts: 8700
- Joined: Wed Dec 10, 2014 6:15 pm
- Location: Kent
- Has thanked: 1599 times
- Been thanked: 4609 times
Mine are fine although a bit grubby from lack of care!
Equinox 800 x2
- Posts: 167
- Joined: Sun Oct 26, 2014 9:52 pm
- Has thanked: 44 times
- Been thanked: 37 times
have had to clean mine a number of times usually rubbing it with my finger tip seems enough to rub green off it seems to effect my charging when it is not clean enough the green light glows very dim until I get charge points cleaned up.
- Posts: 1157
- Joined: Sun Sep 13, 2015 5:53 pm
- Has thanked: 297 times
- Been thanked: 314 times
Cover with a bit of insulation tape I do my French stick coil contacts with a bit to keep them cleanish also as said above I rinse off the coil especially when been to the beach