ALERT The MDF has a monthly Prune of all Members that have Zero Posts to their Accounts to Free up Resources. However Just 1 Single Post will keep your account open indefinitely.

Coil lug repair/upgrade ad on for equinox 600/800

Only for the discussion of the Minelab Equinox series of metal detector within this forum.
Post Reply
Junior
Posts: 1331
Joined: Sun Sep 13, 2015 5:53 pm
Has thanked: 418 times
Been thanked: 400 times

Coil lug repair/upgrade ad on for equinox 600/800

Post by Junior »

Saw these on a rally and avaible from certain auction site and prob else where .

Looks like avaible for 3030 also ....

Minelab Equinox 800 - 600 - 15'' Coil Yoke Stiffener and Repair - RED also avaible on other pages ones for smaller coils

Info ....
2 In 1 - Stiffener and Repair Yoke - RED

Minelab Equinox 800 - 600 Coil Yoke Stiffener and Repair Yoke

The NOX 600 and 800 coil yoke stiffeners will make your coils less prone to breaking by reinforcing the existing yoke plates. There are to versions available one for the 11- and 15-inch coil and one for the 6-inch coil.

Also available is the repair yoke for the 11- and 15-inch coil. If your yoke tab breaks off, you can use this part to repair the coil using two cable ties to hold the yoke plate in position securely.

This is for anyone who has a broken yoke already and uses 2 cable ties to fix the repair plate in place. To fit simple, disassemble the coil from the steam and put the repair plate in place, and secure around the coil body with 2 off x 5 mm cable ties. Reassemble the coil back onto the shaft placing the broken yoke tab in place to get the right spacing.

This topic has 18 replies

You must be a registered member and logged in to view the replies in this topic.


Register Login
 
Post Reply

Return to “Minelab Equinox Forum”