Wiring headphone to Manticore

[TINTIN2500]

Hello

I bought a Manticore connector because my Aqua-tek Manticore Headphone (from US) was not properly done, and there is a contact failure when it's plugged in.. (work, not work, work....)

So I'm looking for the schematic to weld it back together and know what goes with what.

Thanks all.

[SimplexSimonx]

Hello

I bought a Manticore connector because my Aqua-tek Manticore Headphone (from US) was not properly done, and there is a contact failure when it's plugged in.. (work, not work, work....)

So I'm looking for the schematic to weld it back together and know what goes with what.

Thanks all.

I would use your flaky Aquatek headphones to help you work out which pins are connected to what with a multimeter/continuity tester.

[Phil2401]

Minelab, as all other manufacturers, including Aqua-tec, do not make their schematics publicly available, for obvious reasons. Looks like a session of trial and error .... good luck! Or just return the non-working component for a refund.

Phil

[TINTIN2500]

I would use your flaky Aquatek headphones to help you work out which pins are connected to what with a multimeter/continuity tester.

Hello Simonx

Thanks for you prosition. I accept it with pleasure.
I've got few testers, but I don't really know how to use them, apart from the very-basic stuff.

I would return it, but the guy who is doing it : Frank Lapergolo from detectAmerica is not responding ... Bizarre

[Alan Black]

Hello

I bought a Manticore connector because my Aqua-tek Manticore Headphone (from US) was not properly done, and there is a contact failure when it's plugged in.. (work, not work, work....)

So I'm looking for the schematic to weld it back together and know what goes with what.

Thanks all.

Manticore, Nox, 3030 are all wired the same.

IMG_20250414_183702.jpg

[TINTIN2500]

Is this diagram ok ?
I can solder anything, but my electric knowledge is poor.