Only topics related to the Garrett ACE 250 metal detector here.
- Posts: 11
- Joined: Tue Aug 25, 2009 9:43 pm
- Location: ely cambs
thanks for manual . been having few problems today with erratic signals . still digging up trash when machine says different. any ideas .
- Posts: 10790
- Joined: Sun Jun 13, 2010 8:52 pm
- Location: Kent
- Has thanked: 159 times
- Been thanked: 117 times
Hi add, no sorry, but might be worth a seperate post in the ACE section asking for help, there are may owners of that machine on here that I am sure can help
- Posts: 3302
- Joined: Tue Dec 14, 2010 10:38 pm
- Location: Chester
- Been thanked: 1 time
Mineralisation in the soil, I am on one part of a field where every signal I stick the spade in to see if the signal is true. It changes most of the time on this one part of the field.
Its better out of the ground and in your hand for the history or monetary value rather than left in the ground to rot doing nothing for anyone.
Member of Cheshire Metal Detecting Society
In love with Mr Deus for ever.
- Posts: 33
- Joined: Fri Jan 06, 2012 5:37 am
Hi Dave, Iv'e only been using the ace 250 for a little while, actually about 2 years & then only sporadically. Here's what I found with signals.......when I sweep the coil & it sounds a certain way in one direction & gives another tone in the opposite direction, I know it's trash, usually a nail or something like that. Also, when the ace gives a couple of short beeps over a target I don't bother. You'll find that if you get a dd coil the target separation on the ace will improve fairly drastically. I've had Aussie 5c coins ring up as foil so it isn't easy to work out sometimes. Aussie $1.00, $2.00, !c & 2c pieces along with the old pennies & halfpennies all give that magic coin ring.
I found it just "clicked" for me after a lot of digging jink......hope that helps?
- Posts: 2508
- Joined: Thu Nov 11, 2010 11:16 am
- Location: Swingin' un Diggin'
- Has thanked: 7 times
- Been thanked: 30 times
add wrote:thanks for manual . been having few problems today with erratic signals . still digging up trash when machine says different. any ideas .
Give us an idea what mode etc you are using and what you're coming up with. If you make slow sweeps over a target and it sounds off clearly and the display read out does not alter then you are onto something good. If the display readout jumps from one end to another then it's most likely junk.