Only for the discussion of the Minelab Explorer SE metal detector within this forum.
- Posts: 2
- Joined: Mon Feb 07, 2011 11:15 am
I was wondering does anyone have a good programme for Roman Coins?
- Posts: 8153
- Joined: Sun Nov 27, 2011 8:21 pm
- Location: North Lincolnshire
- Has thanked: 997 times
- Been thanked: 1718 times
Hello 'Bryazz, Long time no see, welcome back
It's quite a while since I used the Explorer but I seem to remember it was pretty good at locating even the smaller denominations of roman coins, so I never had cause to look for a specific programme to find them. All the best - Regards ss47
Arado 130 - Garrett Groundhog - Tesoro Eldorado - Fisher 1265X - Goldmax Power Makro Racer. Homemade Harness!
- Posts: 2122
- Joined: Tue Apr 12, 2011 9:17 am
- Has thanked: 555 times
- Been thanked: 308 times
No such thing. Especially if there aren`t any Roman coins in the ground to be found.
Opinions expressed on MY posts are mine and NOT those of any democratic organisation I volunteer for.
- Posts: 7267
- Joined: Wed Dec 10, 2014 6:15 pm
- Has thanked: 1000 times
- Been thanked: 3477 times
Just about any Explorer programme should find denarii and the large Roman coppers. Siliqua behave just like hammies but bear in mind that some of them are clipped very small indeed. The problem with small Roman coppers are twofold: some, like minims, are very small indeed and others like AE4s often give an irony signal. The solution is to use an open screen with just nails blanked out and everything else ramped up as high as you can bear it. I prefered both fast and deep on because it aided pinpointing but some people say you shouldn't. Swing low and slow and dig everything that isn't obviouly iron. Worked for me anyway, in fact a good all round programme.
Equinox 800 x2
Explorer II (for the Thames)