Help first machine

All discussion specific to the Cscope CS3MXI Metal Detector.
Post Reply
DaveG
Posts: 7
Joined: Mon Aug 20, 2018 5:04 pm
Has thanked: 11 times

Help first machine

Post by DaveG » Thu Aug 23, 2018 7:25 pm

Just bought first cs 3mxi and when I turn it on I don’t get any sound until I turn sensitivity to about 9 on the lawn in the back garden is this normal ? Please help as I have no idea and no instructions 🤔Thanks in advance



User avatar
sweepstick47
Moderator
Posts: 9724
Joined: Sun Nov 27, 2011 8:21 pm
Location: North Lincolnshire
Has thanked: 1652 times
Been thanked: 2403 times

Re: Help first machi

Post by sweepstick47 » Thu Aug 23, 2018 7:33 pm

Here's a link to obtain a downloaded copy of the Instruction Manual - Regards ss47
Instruction Manual
A disservice is no service at all.

User avatar
Wessexlad
Posts: 466
Joined: Sat Dec 30, 2017 4:47 pm
Location: S Cambs
Has thanked: 86 times
Been thanked: 177 times

Re: Help first machi

Post by Wessexlad » Thu Aug 23, 2018 7:34 pm

Here you go. https://www.csmetaldetectors.com/archiv ... ion-manual

edit: Curses! Beaten by a minute.
I was planning to visit every shopping centre in the country, but I realised that when you've seen one, you've seen a mall.

Steevo45
Posts: 145
Joined: Tue Jan 24, 2017 10:11 pm
Has thanked: 42 times
Been thanked: 26 times

Re: Help first machi

Post by Steevo45 » Thu Aug 23, 2018 7:45 pm

Mine being the older one doesn’t have numbers just black, green and red around the dial, green being the optimum level. The green section is quite far round around 2/3rds of the way so guessing around 9 if it was numbered. The lower end with no sound means sensitivity too low so as long as you get the constant tone and then turn it down a touch just loud enough to hear it is working at the optimum level. Hope that made sense and helps you out

garrettoldboy
Posts: 703
Joined: Fri Jun 22, 2018 8:46 am
Has thanked: 134 times
Been thanked: 280 times

Re: Help first machine

Post by garrettoldboy » Fri Aug 24, 2018 7:26 am

hello, let us know how you get on DaveG??

DaveG
Posts: 7
Joined: Mon Aug 20, 2018 5:04 pm
Has thanked: 11 times

Re: Help first machine

Post by DaveG » Wed Aug 29, 2018 8:42 am

Ye still sitting about 9 but only been out once since I got it, couple of tin cans and a large iron bolt sens set at about 3/4 Thanks

andy fraggle
Posts: 554
Joined: Wed Oct 05, 2011 6:44 pm
Location: kent
Been thanked: 12 times

Re: Help first machine

Post by andy fraggle » Wed Aug 29, 2018 9:44 am

Hi there, the audio threshold will come in towards the end of the sensitivity control range. For optimal sensitivity adjust this control until the audio is only just heard and only back this control off if in an electrically noisy enviroment or in a high mineral area.

Hope this helps

Andy Fraggle

Post Reply

Return to “CScope CS3MXI Forum”