Newbie question. Iron

[diggin+fishin67]

Hi All.
Been out with the Deus again. (didn't find much.) just wondering if any one else has a problem
with iron giving high numbers on the remote?

I've had them up into the ninety's today. Especially when it's deep. You get a signal, and keep having
to dig further down. All the time getting a high number value. Maybe there's a way of checking on another setting?

And i think i will take both stems apart. And wipe down before storing away. managed to put a scratch all way down the lower stem. Caused by a tiny piece of grit. either on the stem. Or in the
opening, where it slides through.

[Jonesy]

This is a link to a good guide on using the deus.
http://www.metaldetectingworld.com/deci ... nses.shtml" onclick="window.open(this.href);return false;

[bob79]

What programme are you using?

Bob

[deltron]

If you use the remote, the horse shoe will tell you if it iron. Bad to the left. good to the right.

[deltron]

If you use the remote, the horse shoe will tell you if it iron. Bad to the left. good to the right.

[diggin+fishin67]

Hi thanks for reply's.
Not sure exactly which program, as was switching through them. I know about the horseshoe. But was
going with the high tone, and vdi numbers. As I have watched a clip on using Deus, saying to go by
the tones, and not so much the numbers. (Gary's detecting clip.)

Will be interesting to see next time. If you can actually get high pitch signal's, and high number readings. With the horseshoe filling in on the left.

Many Thanks.