My six pences and an odd weight

Metal detecting beaches, rivers and other water related areas.
Forum rules
Please note: This forum is intended for accounts of your day's detecting and finds, etc. If you require an identification of your finds, please use our Finds Identification facility. Any replies here offering a ID will be removed.
Post Reply
Pav
Posts: 414
Joined: Thu Nov 15, 2012 9:11 pm
Has thanked: 27 times
Been thanked: 8 times

My six pences and an odd weight

Post by Pav »

Pulled my six pences together this evening with the idea to clean them. The 1889 one was clean so just polished with some metal polish wadding. The 1930 one was dirty, so used the electrolysis process then polished. It fizzes, but I was expecting a magic solution to getting these to shine. Would others go about cleaning these up the same way?

Image
(These were found over the last year)

I have been searching a few new spots over the past week. Mostly fishing weights but did discover this strange weight? .. Its big for fishing and has lettering on the side of it. Any ideas? Fishing or something else?

Image
lord lovell
Posts: 10632
Joined: Sat Feb 25, 2012 9:21 pm
Has thanked: 1 time
Been thanked: 42 times

Post by lord lovell »

nice coinage well saved ::g
John and Dawn
Posts: 260
Joined: Mon Nov 05, 2012 9:38 pm
Location: Hucknall, Notts
Been thanked: 1 time

Post by John and Dawn »

Its an anode off a boat.
You do not have the required permissions to view the files attached to this post.
John and Dawn.

CTX 3030 (X2)
Ringfinder sand scoop
Pav
Posts: 414
Joined: Thu Nov 15, 2012 9:11 pm
Has thanked: 27 times
Been thanked: 8 times

Post by Pav »

:) thank you! , I knew someone here would ID it! , that was quick. I knew it was too large for trolling from where I found it, as at high water it would only be a few meters over a snaggy bottom.
User avatar
sweepstick47
Moderator
Posts: 23491
Joined: Sun Nov 27, 2011 8:21 pm
Location: North Lincolnshire
Has thanked: 6108 times
Been thanked: 8540 times

Post by sweepstick47 »

John and Dawn wrote:Its an anode off a boat.
Hi J and D, That was an interesting ID. What was the function of an 'Anode' in relation to boats? I'm only familiar with that term used in valve radios (mains rectifier valve I believe) .......yes I'm that old!! Cheers ::g
A disservice is no service at all.
John and Dawn
Posts: 260
Joined: Mon Nov 05, 2012 9:38 pm
Location: Hucknall, Notts
Been thanked: 1 time

Post by John and Dawn »

As seawater is conductive you get electrolysis between different types of metals. A stainless prop shaft and brass propeller for instance. Without the anode the prop would get eroded away in a short time. The anode corrodes quicker thereby protecting the prop. Cheap and easy to replcace the anode yearly not so the prop!"
John and Dawn.

CTX 3030 (X2)
Ringfinder sand scoop
John and Dawn
Posts: 260
Joined: Mon Nov 05, 2012 9:38 pm
Location: Hucknall, Notts
Been thanked: 1 time

Post by John and Dawn »

sweepstick47 wrote:
John and Dawn wrote:Its an anode off a boat.
Hi J and D, That was an interesting ID. What was the function of an 'Anode' in relation to boats? I'm only familiar with that term used in valve radios (mains rectifier valve I believe) .......yes I'm that old!! Cheers ::g
Brought up with valves :D Dad was a radio ham, G3OBJ
Golf 3 Old Box Of Junk.
Brilliant watching him build radios and talk to people all over the world.
John and Dawn.

CTX 3030 (X2)
Ringfinder sand scoop
User avatar
Ten pence!
Posts: 1674
Joined: Mon Dec 09, 2013 10:42 pm
Location: Norfolk
Has thanked: 607 times
Been thanked: 923 times

Post by Ten pence! »

The only way to clean up cruddy silver coinage that has little value other than the silver content is to put the lot into a barreling machine with a tablespoon of burnishing soap, after a couple of hours they will positively gleam! Also very good for cleaning up beach found coins to avoid those strange looks you get from shopkeepers when you hand over pink silvers and grey pound coins.
User avatar
Danzigman
Posts: 13663
Joined: Sun Aug 07, 2011 8:31 am
Location: Denmark - Frederikshavn.
Has thanked: 762 times
Been thanked: 1336 times
Contact:

Post by Danzigman »

Think the od Weight is a ballast to keep something upright. And not a anode..
If the Rod to fasten it, is not iron, then it is not an anode.. I look like full lead..
XP DEUS. GPP VII. GARMIN etrex 20.
https://www.facebook.com/Danzigman/
John and Dawn
Posts: 260
Joined: Mon Nov 05, 2012 9:38 pm
Location: Hucknall, Notts
Been thanked: 1 time

Post by John and Dawn »

Good point, could be .
::g
John and Dawn.

CTX 3030 (X2)
Ringfinder sand scoop
Pav
Posts: 414
Joined: Thu Nov 15, 2012 9:11 pm
Has thanked: 27 times
Been thanked: 8 times

Post by Pav »

Yep lead. It was going in my scrap lead pile, but it looked like it had a story to tell first.
I am searching a few fishing hot spots at the moment. Lots of lead, but the odd coin. I am sure amongst that lead are rings that come off during a power cast.

I need to make a tumbling machine next! Shouldn't be too difficult.
John and Dawn
Posts: 260
Joined: Mon Nov 05, 2012 9:38 pm
Location: Hucknall, Notts
Been thanked: 1 time

Post by John and Dawn »

Pav wrote:Yep lead. It was going in my scrap lead pile, but it looked like it had a story to tell first.
I am searching a few fishing hot spots at the moment. Lots of lead, but the odd coin. I am sure amongst that lead are rings that come off during a power cast.

I need to make a tumbling machine next! Shouldn't be too difficult.
Aldi has got ultrasonic cleaner in on Sundays offers,maybe ok for cleaning coins and stuff £22 !!

Been told it is a decent bit of kit and worth the money
John and Dawn.

CTX 3030 (X2)
Ringfinder sand scoop
John and Dawn
Posts: 260
Joined: Mon Nov 05, 2012 9:38 pm
Location: Hucknall, Notts
Been thanked: 1 time

Post by John and Dawn »

Apologies not a tumbler.
Might be worth a look though

https://www.aldi.co.uk/en/specialbuys/s ... c-cleaner/" onclick="window.open(this.href);return false;
John and Dawn.

CTX 3030 (X2)
Ringfinder sand scoop
User avatar
geomorphicmat
Posts: 134
Joined: Mon Feb 04, 2013 4:43 pm
Location: Bristol
Has thanked: 3 times
Been thanked: 53 times

Post by geomorphicmat »

Pav,
the article in the first post is a very interesting read for cleaning silver coins.
http://www.metaldetectingforum.co.uk/vi ... 22&t=56204
To summarise, the best chemical cleaner is a 10% solution of acetic acid. Distilled vinegar is about 6% so this will work fine, but (i) takes longer and (ii) may need repeated soakings.
It will be less aggressive than barreling and should will leave the coins in a good state.
Cheers, Matt
CTX3030 sold. XP Deus II purchased!
Profind 25 broken. XP MI-6 purchased!
User avatar
FUBAR
Posts: 8016
Joined: Sat Aug 14, 2010 1:23 pm
Has thanked: 564 times
Been thanked: 1060 times

Post by FUBAR »

In all the time I have been detecting think I have only found maybe 6 tanners.
Post Reply

Return to “Detecting Beaches, Rivers and Water”

Who is online

Users browsing this forum: No registered users and 47 guests