Hi all, bit of help needed. The plastic outer covering of the cable on my GMP is going brittle and breaking up. I noticed a week ago that I could see the small wires where a 3/4” length of outer caseing was missing. Thought it was just wear and applied some black tape, just now I noticed another bit missing. So, are replacement cables available? Who from? And is it a diy job to change?
Thank you
Power Cable
-
bob79
- Posts: 2246
- Joined: Mon Aug 15, 2011 1:01 pm
- Location: Oxon/Wilts border.
- Has thanked: 254 times
- Been thanked: 1457 times
Hi Steve, Regton's would be your best bet, they are the UK authorized repair centre. Give Nigel or Marcus a ring and explain the situation they will advise you on what's the best option.
Bob
Bob
-
BAMBAM
- Posts: 1266
- Joined: Sun Aug 12, 2012 10:01 am
- Location: Gods own County
- Has thanked: 259 times
- Been thanked: 744 times
Might be cheaper to get a secondhand coil off a site!
BAMBAM
East Riding of Yorkshire .. Home of the ancient Parisi Tribe,
Semper exspectare et ecce subito!
(Always expect the unexpected!)
Detectors: Garrett Vortex VX9 | Garrett Z Lynk Pro Pointer | Quest Q35 & XP ADX 150
East Riding of Yorkshire .. Home of the ancient Parisi Tribe,
Semper exspectare et ecce subito!
(Always expect the unexpected!)
Detectors: Garrett Vortex VX9 | Garrett Z Lynk Pro Pointer | Quest Q35 & XP ADX 150
-
Fusion
- Posts: 6126
- Joined: Thu Sep 16, 2010 11:47 am
- Location: Herts
- Has thanked: 29 times
- Been thanked: 2025 times
If it's restricted to small sections, heatshrink sleeving will likely be OK, it should buy you a few more years use.
Who is online
Users browsing this forum: No registered users and 50 guests