Etrac to Equinox shaft conversion
-
Swiss Rolly
- Posts: 461
- Joined: Mon Aug 30, 2021 4:54 pm
- Has thanked: 307 times
- Been thanked: 661 times
Etrac to Equinox shaft conversion
I'll ask my stupid question before I go off to my shed and reinvent the wheel but is there anyway to convert or a conversion kit that takes E-trac shafts to fit on the Equinox. Looking from a cost perspective here, for Equinox quick coil change you would also need a lower shaft. Another £30 or so.
-
Swiss Rolly
- Posts: 461
- Joined: Mon Aug 30, 2021 4:54 pm
- Has thanked: 307 times
- Been thanked: 661 times
...oh yes and I am aware it would be a square peg in a round hole.
-
clint
- Posts: 4444
- Joined: Tue Jun 28, 2011 9:12 pm
- Location: Wrexham
- Has thanked: 78 times
- Been thanked: 636 times
Perhaps fitting the Equinox control box to an etrac base might be easier?
Etrac.13" Ultimate Coil.CP3 TT`s
8x6 sef
Euroace.
Deteknix Pointer,camo,oh yeah! ...does what it says on the box..
Garrett Propointer..ok...(now it's fixed!)
Jeff`s big tool!
8x6 sef
Euroace.
Deteknix Pointer,camo,oh yeah! ...does what it says on the box..
Garrett Propointer..ok...(now it's fixed!)
Jeff`s big tool!
Who is online
Users browsing this forum: No registered users and 42 guests